January 9, 2013
Start Manufacturing at Home with the Afinia 3D Printer
Brian McLaughlin over at Wired gives the Afinia H-Series 3D Printer — ready to go out of the box— a rave review after trying it out. And agrees with it's winning the awards for Easiest to Use, Easiest to Setup and Best Overall Experience in the Make Magazine 3D printer showdown.
The Afinia printer comes almost ready to go out of the box. All the user needs to do is remove a couple shipping clips and attach the filament spool arm. This done in a matter of minutes and the printer is plugged in with the included USB cable and power cable quickly and easily. The printer fits well on our desk right next to our HP inkjet. Installing the software from the included CD is also a breeze. Within less than an hour the printer is powered, connected to the computer, the software is installed, and I was ready to get the printer calibrated.
Read full article.
The Permanent Link to this page is: https://textually.org/3DPrinting/2013/01/031559.htm